Note
Archived discussion. This page is a verbatim copy of a thread from
community.ansel.photos, the Ansel community forum, which ran from March 2023
until it was taken offline in June 2025 after the site was compromised — a counterfeit
site had been planted inside the forum software, so the whole thing had to come down.
The original address was https://community.ansel.photos/view-discussion/highlight-reconstruction-not-copied-when.
You can check this copy against the snapshot in the Internet Archive.
Answers may refer to older versions of Ansel, and image attachments did not survive the shutdown. Current discussion happens on GitHub Discussions .
Posted by koslowj on 2024-09-24.
When copying the development stack from a picture where highlight reconstruction is active to similar pictures, in the result highlight reconstruction is not active (but set to the value of the first picture). So I need to switch it on manually. Again, version 85f2b8b, self-compiled under Gentoo-Linux.
Replies
Jiyone — 2024-09-24
You should report bug on github
https://github.com/aurelienpierreeng/ansel/issues
Aurélien Pierre — 2024-10-21
Might be related to https://github.com/aurelienpierreeng/ansel/issues/376
koslowj — 2024-11-16
Possibly a related problem, in version 922.g7f23d9d38 , self-compiled on Linux:
For black-and-white pictures I like to develop the color version first, then open a second instance of the color calibration and move this above filmic in the development stack. Then I use this second copy as a channel mixer.
When I try to copy such a development stack to a different picture, the second instance of the color calibration is moved back to its original position and no longer sits above filmic; I have to move it back there again.
Translated from English by : Automatically generated. In case of conflict, inconsistency or error, the English version shall prevail.