Control functionality in the darkroom view and associated modules.

algemeen

pen pressure control for brush masks
Controls how the pressure reading of a graphics tablet impacts newly generated drawn mask brush strokes. You can control the brush width, hardness and opacity. “Absolute” control means that the pressure reading directly defines the attribute with a value between 0% and 100%. “Relative” means that the pressure reading adjusts the attribute between zero and the pre-defined default value (default off).
smoothing of brush strokes
Sets the level for smoothing of drawn mask brush strokes. Stronger smoothing leads to fewer nodes and easier editing at the expense of lower accuracy.
scroll down to increase mask parameters
By default, scrolling your mouse up increases the value of the relevant shape parameters in drawn masks. Set this preference to reverse the behavior (default off).
pattern for the image information line
Set the information to be displayed in the image information line. You can use any variables in the variables section as well as $(NL) for a new line. You can also include formatting (bold, italic, colors etc).
position of the image information line
Choose the darkroom panel in which the image information line is displayed. Choose between “top left” “top right” “top center” “bottom” and “hidden” (default “bottom”).
border around image in darkroom mode
Display the center image in darkroom mode with an outside border of the given number of pixels (default 20).
toon laadscherm tussen afbeeldingen
Grijs laadscherm weergeven bij navigeren tussen afbeeldingen in Ontwikkelen. Schakel deze optie uit om een eenvoudig toastbericht weer te geven en de vorige afbeelding op zijn plaats te laten totdat de volgende afbeelding is geladen. Houd er rekening mee dat het uitschakelen van deze optie erg handig kan zijn om snel dubbele afbeeldingen te vergelijken, maar er kunnen problemen zijn met lange laadtijden (waardoor je denkt dat de volgende afbeelding al is geladen) en je kan visuele artefacten waarnemen terwijl de volgende afbeelding wordt geladen (standaard aan).

modules

display of individual color channels
Control how individual color channels are displayed when activated in the parametric masks feature. You can choose between “false color” and “gray scale” (default “false color”).
verwijder ingebouwde voorkeuren voor verwerkingsmodules
Indien ingeschakeld, worden alleen door de gebruiker gedefinieerde voorinstellingen weergegeven in het voorinstellingenmenu voor verwerkingsmodules – ingebouwde voorinstellingen worden verborgen (standaard uit).
show the guides widget in modules UI
Enable this to show the local guides & overlays interface directly within the UI of the modules that support it (default on).
show right-side buttons in processing module headers
Choose whether to show the four buttons (mask indicator, multi-instance menu, reset, presets menu) on the right-hand-side of the module header for processing modules. These buttons will always appear when the mouse is over the module. At other times they will be shown or hidden according to this preference selection:
  • always: always show all buttons
  • active: only show the buttons when the mouse is over the module
  • dim: buttons are dimmed when mouse is not over the module
  • auto: hide the buttons when the panel is narrow
  • fade: fade out all buttons when the panel narrows
  • fit: hide all the buttons if the module name doesn’t fit
  • smooth: fade out all buttons in one header simultaneously
  • glide: gradually hide individual buttons as needed
(default always)
prompt for name on addition of new instance
If enabled, when creating a new instance of a processing module, a prompt will be immediately displayed allowing you to set a name for the new instance (default on).