Note
Archived discussion. This page is a verbatim copy of a thread from
community.ansel.photos, the Ansel community forum, which ran from March 2023
until it was taken offline in June 2025 after the site was compromised — a counterfeit
site had been planted inside the forum software, so the whole thing had to come down.
The original address was https://community.ansel.photos/view-discussion/vectorscope-size.
You can check this copy against the snapshot in the Internet Archive.
Answers may refer to older versions of Ansel, and image attachments did not survive the shutdown. Current discussion happens on GitHub Discussions .
Posted by Massimo on 2024-12-21.
I struggle to set up the size of GUI with my system. My monitor is 5120x2880, 27 inches (218 DPI) and Windows resize is set to 250%. The best compromise is character 5.0 points (minimum) and DPI GUI and text 218. I would prefer a smaller layout, but if I reduce DPI I get non homogeneous text.
But the problem is with vectorscope. It resizes downto 22% of the display approximately (that is huge), then it is clipped on both sides.
By the way, I’m using 0.0.0+922~g7f23d9d38 on Windows 10.
Replies
Massimo — 2025-04-18
Having understood that is possible to change the GUI in the CSS text box, I roll back to system font size and resolution, that yields a much better overall layout size, and I try to fix the non homogeneous text with CSS tweaks.
Unfortunately I don’t find any way to reduce the huge text shown in left and right panel, see attached image. Does someone has a suggestion?
[attachment lost: image was hosted on the retired forum]
Translated from English by : Aurélien Pierre, ChatGPT, Claude, Claude (Anthropic). In case of conflict, inconsistency or error, the English version shall prevail.