Note
Archived discussion. This page is a verbatim copy of a thread from
community.ansel.photos, the Ansel community forum, which ran from March 2023
until it was taken offline in June 2025 after the site was compromised — a counterfeit
site had been planted inside the forum software, so the whole thing had to come down.
The original address was https://community.ansel.photos/view-discussion/small-problem-with-the-retouch-module.
You can check this copy against the snapshot in the Internet Archive.
Answers may refer to older versions of Ansel, and image attachments did not survive the shutdown. Current discussion happens on GitHub Discussions .
Posted by koslowj on 2025-01-18.
The elliptical shape in the retouch module gives me some problems: after initially placing an ellipse to remove a blemish, I no longer can shift or rotate it at will. It seems to jump back into its original position in most cases; rotation especially is almost impossible. Edit: forgot to mention that this concerns version e2f5d0a.
Replies
koslowj — 2025-01-19
In version 55f5596 ellipses still show some reluctance to be placed exactly where I want them, both with respect to rotation as well as translation. Circles seem to show this also for translation. These operations used to be much smoother.
Aurélien Pierre — 2025-01-19
See https://github.com/aurelienpierreeng/ansel/issues/405
koslowj — 2025-01-19
Apparently, this phenomenon is not restricted to the retouch module but affects elliptical masks in other settings as well. Other masks, e.g. triangular ones, are also difficult to translate precisely: the seem to jump a little bit from their intended position.