Note
Archived discussion. This page is a verbatim copy of a thread from
community.ansel.photos, the Ansel community forum, which ran from March 2023
until it was taken offline in June 2025 after the site was compromised — a counterfeit
site had been planted inside the forum software, so the whole thing had to come down.
The original address was https://community.ansel.photos/view-discussion/image-information.
You can check this copy against the snapshot in the Internet Archive.
Answers may refer to older versions of Ansel, and image attachments did not survive the shutdown. Current discussion happens on GitHub Discussions .
Posted by themetman on 2025-02-05.
I shoot Digital Infrared with a converted camera to 630nm and two additional filters at 700nm and 830nm.
I use three White Balance PreSets for these filters.
Darktable shows the White Balance in the “Image Information” as “One Touch WB 1” which is a handy reminder of which filter I used for the shot.
Ansel does not show this field. I prefer using Ansel to Darktable. It would be a simple and useful addition to the Image Information.